in 3dprint ~ read.

Got new 3D printer - Creality CR-10S

IMG_4081_1024x1024

So after a long time I finally got 3D printer. It took a while to get it (as 1st one ordered from GearBest and that didn't go too well)

Box was huge and assembly was very easy, took me an hour to get it to fully working state. And after few rookie mistakes like bed leveling I got 1st print :)

Few differences from CR-10

  • Dual Lead Screw design will stabilize the printer on larger, tall prints
  • Filament Sensor will alert you when the filament has ran out or broken
  • New Motherboard (ATmega2560)
  • Power outage (didn't try but not sure if that is working or not)

I know we all print calibration boxes and Benchy but you need to start somewhere right ;)

Later will post some prints and 99% that will work on firmware mods
(as whole printer is running Marlin - opensource 3D printer firmware)
https://github.com/MarlinFirmware/Marlin